Build your own oscilloscope and learn how to visualize signals. See the signals you learn about in real life!
Despite the low cost, this oscilloscope has a lot of features found only on expensive units like signal markers, frequency, dB, true RMS readouts,...
A powerful auto-setup function will get you going in a snap!


Note: This scope cannot be used to perform measurements on voltages higher than 30Vpp.

Specifications

• high contrast LCD: 64 x 128 pixels with white LED backlight
• maximum sample rate: 1MS/s for repetitive signals, 100kS/s in real time
• input amplifier bandwidth: 200kHz (-3 dB)
• measurements can be performed up to: 100kHz
• input impedance: 100kohm // 20pF
• maximum input voltage: 30Vpeak (AC + DC)
• input coupling: DC and AC
• AD resolution: 8 bits
• run modes: run, single
• trigger level adjustable: in 16 steps
• timebase range: in 15 steps, 10µs/division to 500ms/division
• input sensitivity range: in 6 steps, 100mV/division to 5V/division
• test output: 1.95kHz / 3.3Vpp
• full auto set up for: Volt/div and time/div (or manual)
• sensitivity down to 10mV
• readouts: DC, AC+DC, true RMS, dBm, Vpp, min. & max.
• time and voltage markers readout
• frequency readout (through markers)
• battery operated: 4 x AAA batteries (max. 100mA)
• power save mode
• dimensions: 80 x 115 x 40 mm / 3.14 x 4.52 x 1.57"
• weight: 190g (6.70 oz) with batteries

Extras

• Hint

  Use the EDU06 oscilloscope tutor kit to explore the functions of your EDU08 scope.